Pulling the ceiling down

The other job we wanted to complete while we had the bus with us in NC was pulling the ceiling down. Some skoolie conversions don’t fully gut the bus; it’s really a personal preference  and since we plan to take the bus out west to colder climates, we are planning to strip the bus down to the outer wall.

We were really grateful that the ceiling panels were held up by screws, not rivets. This saved us a TON of time! To pull the steel panels down we used impact drills. It was a pretty quick process; only a few screws were stripped which meant we had to use the angle grinder to get them out.

IMG_7151

IMG_7145
Screws everywhere!

 

Once the panels were down, there was a thin layer of fabric below the fiber glass. When the fiber glass came down we used wire brushes to clean off the residual fibers.

 

Fiber Glass Gear
Ready to pull down fiber glass!

 

This was definitely a messy job! There was a lot of clean up afterwards to get all the fiber glass out of the bus.

IMG_7153

 

3 thoughts on “Pulling the ceiling down

Add yours

    1. Hey Uncle Andrew! We have been looking into rock wool as an alternative to foam however to get the same R-value as foam we would need so much rock wool. We’re still researching though, would love to avoid foam if possible.

      Like

Leave a Reply to audreylou Cancel reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

Powered by WordPress.com.

Up ↑

%d bloggers like this: